So I buy a USBtinyISP Programmer to do said bootloader install. I figure it’s because maybe the board doesn’t have a bootloader so can’t take a new firmware. Using PlatformIO, I was able to build Marlin 2.x for the LPC1768 environment (which is what I believe the MKS Base board requires), but am unable to upload. I figured maybe the problem was that CNCJS states it supports Marlin 2.x and the board is running 1.x, so I tried to upgrade it. ![]() the mill is fine, it’s just the remote control that isn’t working). However, I can’t get anything I do in CNCJS to result in any motion by the printer (jogs, etc). The CNCJS app recognizes the printer when plugged in via USB (a USB-C to USB-B adapter), and can connect to it via its console. Unlike the previous owner, I need to drive it from a mac (2016 Macbook Pro). ![]() I recently bought a used Burly setup with an MKS Base 1.2 board running Marlin 1.1. I hope this is the right subforum for my question.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |